Test System Release Notes

From OpenMotics
Revision as of 10:14, 24 September 2021 by Wilbert (talk | contribs) (→‎V1.0.18)
Jump to navigation Jump to search

General

The OpenMotics Test System for GEN3 hardware has firmware running on the PCB of the CAN Control that acts as Test Controller. Below, you can find the different release of this firmware.

See Test System to have more detailed information.

V1.0.19

Date: 24/09/2021

Resolved bugs

Added functionality

  • CLI instruction "hardware version read" has been added
  • CLI instruction "hardware version write" has been added

V1.0.18

Date: 24/08/2021

Resolved bugs

Added functionality

  • CLI Instruction "sr" has been added:
    • This instruction reads the serial number only without doing any other tests
    • In this version, this instruction is only supported for the Brain and Brain+
    • Only works with Brain Fw 1.0.109 or higher
  • CLI Instruction "sw" has been added:
    • This instruction writes the serial number only without doing any other tests
    • In this version, this instruction is only supported for the Brain and Brain+

V1.0.17

Date: 17/08/2021

Resolved bugs

Added functionality

  • Master Firmware V1.0.107 and higher has modified CAN parameters. This release of the Test firmware has the modified CAN parameters as well.