Difference between revisions of "Test System Release Notes"

From OpenMotics
Jump to navigation Jump to search
Line 20: Line 20:
 
* Full support of "sr" (serial read) and "sw" (serial write) of Brain and Brain+:
 
* Full support of "sr" (serial read) and "sw" (serial write) of Brain and Brain+:
 
** Brain(+) Module (Fw Version 1.0.128 or higher is needed)
 
** Brain(+) Module (Fw Version 1.0.128 or higher is needed)
 +
* Beta version of Can Control testing has been implemented but not yet fully tested
  
 
== V1.0.20 ==
 
== V1.0.20 ==

Revision as of 10:49, 7 February 2022

General

The OpenMotics Test System for GEN3 hardware has firmware running on the PCB of the CAN Control that acts as Test Controller. Below, you can find the different release of this firmware.

See Test System to have more detailed information.

V1.0.21

Date: 07/02/2022

Resolved bugs

Added functionality

  • Full support of "sr" (serial read) and "sw" (serial write) of RS485 slave modules:
    • Input Module (Fw Version 6.0.27 or higher is needed)
    • 0/1-10V Module (Fw Version 6.0.21 or higher is needed)
    • Output Module (Fw Version 6.0.20 or higher is needed)
    • Can Control Module (Fw Version 6.0.47 or higher is needed)
    • Temperature Module (Fw Version 6.0.18 or higher is needed)
  • Full support of "sr" (serial read) and "sw" (serial write) of Brain and Brain+:
    • Brain(+) Module (Fw Version 1.0.128 or higher is needed)
  • Beta version of Can Control testing has been implemented but not yet fully tested

V1.0.20

Date: 25/10/2021

Resolved bugs

Added functionality

  • Prepare Testing of CAN Control (Not yet functional):
    • RS485 Bus test
    • CAN bus test
    • CAN power switch test
    • RS232 port test
    • Buttons test

V1.0.19

Date: 24/09/2021

Resolved bugs

Added functionality

  • CLI instruction "hardware version read" has been added (for uCAN)
  • CLI instruction "hardware version write" has been added (for uCAN)
  • Testing of Brain is supported

V1.0.18

Date: 24/08/2021

Resolved bugs

Added functionality

  • CLI Instruction "sr" has been added:
    • This instruction reads the serial number only without doing any other tests
    • In this version, this instruction is only supported for the Brain and Brain+
    • Only works with Brain Fw 1.0.109 or higher
  • CLI Instruction "sw" has been added:
    • This instruction writes the serial number only without doing any other tests
    • In this version, this instruction is only supported for the Brain and Brain+

V1.0.17

Date: 17/08/2021

Resolved bugs

Added functionality

  • Master Firmware V1.0.107 and higher has modified CAN parameters. This release of the Test firmware has the modified CAN parameters as well.