Difference between revisions of "Program Connector"

From OpenMotics
Jump to navigation Jump to search
Line 31: Line 31:
  
 
For more information how to program a module, please see [[Module Programming]]
 
For more information how to program a module, please see [[Module Programming]]
 +
 +
For the micro CAN module, the connector is different, the pinout is:

Revision as of 19:34, 27 February 2017

On all devices there is a program connector.

Use the AMP - 7-215083-6 from TE connectivity to connect.

7-215083-6.jpg

Description of the pins:

PIN Description
1 MCLR
2 VCC
3 GND
4 DAT
5 CLK
6 DEB

The first 5 pins are the same as the microchip program connector standard. Look in the BOM of the PCB to know what type of microchip IC is used.

The debug pin (pin 6) is a TTL TX UART pin with debug information. (baudrate is standard 115200)

For more information how to program a module, please see Module Programming

For the micro CAN module, the connector is different, the pinout is: