Difference between revisions of "HP Tips & tricks during installation and troubleshooting"

From OpenMotics
Jump to navigation Jump to search
(Created page with "= Introduction = The HP (Heat Pump) module is made to work in combination OpenMotics. This module will allow to built a full electric solution for Heating and Cooling in combi...")
 
Line 8: Line 8:
 
* 2x 0-10VDC outputs
 
* 2x 0-10VDC outputs
 
* 1x Aquastat input
 
* 1x Aquastat input
 +
= Firmware information =
 +
== Release notes ==
 +
The Firmware release notes can be found here:

Revision as of 14:26, 28 December 2021

Introduction

The HP (Heat Pump) module is made to work in combination OpenMotics. This module will allow to built a full electric solution for Heating and Cooling in combination with a Heatpump. The HP module has following connections:

  • 6x NTC (temperature) probe connections
  • 4x 230VAC outputs
  • 2x Relay outputs (dry contacts)
  • 2x 0-10VDC inputs
  • 2x 0-10VDC outputs
  • 1x Aquastat input

Firmware information

Release notes

The Firmware release notes can be found here: