HP Module Release Notes

From OpenMotics
Revision as of 14:00, 7 September 2021 by Wilbert (talk | contribs) (Created page with "== General == The HP Module firmware is published as Open Source since firmware release V6.0.x. Below you'll find all the changes since that release. The firmware updates ha...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

General

The HP Module firmware is published as Open Source since firmware release V6.0.x. Below you'll find all the changes since that release.

The firmware updates happening in the Openmotics portal (Settings - Update) contain not only the firmware update of the Master, but also the firmware of other modules as well as the updates for the Beagle Bone Black. All these different firmware updates are assembled in a package which get's a general version number. This version number which you see in the portal is not the same as the Firmware Version of the Master. To check which firmware version is installed on the Master or any other module, in the Openmotics portal, go to Settings - Maintenance and open maintenance mode by pressing the Connect button. Type the instruction firmware version to read the Master Firmware version.

Important Notes:

  • V6.x.y only works with Gen 3 hardware

V6.0.1

Date: In development

Resolved bugs

Added functionality

  • I2C framework has been implemented to read write front panel, sensors and AD converter
  • Front panel logic has been implemented: Control of front panel leds and button
  • Read/write of the AD IC's (AD7995)