FRAM Model AIO

From OpenMotics
Revision as of 14:00, 30 July 2019 by Wilbert (talk | contribs) (Created page with "== Introduction == The AIO has an onboard FRAM connected via I2C to the DSPIC33E (The Master). This document describes the FRAM memory locations used. == General Configurati...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Introduction

The AIO has an onboard FRAM connected via I2C to the DSPIC33E (The Master). This document describes the FRAM memory locations used.

General Configuration Bytes

Page 0 -> Controller specific data
Page Byte
0 1
Number of output modules: This byte specifies the number of output (output, dim control, shutter/curtain ...) modules known by the Master controller on the RS485 bus. Maximum 80.