Energy Module Calibration

List of commands for the energy module : Energy Module Commands

Calibration of the voltage

• command SVO : FUNC_SetVoltage
• parameter = 1x4 bytes type float in [V]
• There are 3 voltage channels that can be calibrated.
• The parameter should be the voltage connected to one or more of the voltage channels.
• Only the channels that have a voltage above 10V (before calibration) will be calibrated. This way you can calibrate every channel separately or in one shot.
• If the calibrated value deviate more than factor 2 (in both directions), the value will also be 'floored'.

Calibration of the current

• command SCU : FUNC_SetCurrent
• parameter = 1x4 bytes type float in [A]
• There are 12 current channels that can be calibrated.
• The parameter should be the current connected to one or more of the current channels. <<-- what with different current-sensors? should be calibrated with 1 current sensor and an extra parameter should be used to have an extra factor to use in the calculation.
• Only the channels that have a current above 0.1A (before calibration) will be calibrated. This way you can calibrate every channel separately or in one shot.
• If the calibrated value deviate more than factor 2 (in both directions), the value will also be 'floored'.