CAN Eeprom pages

From OpenMotics
Revision as of 18:12, 28 January 2021 by Wilbert (talk | contribs) (Created page with "== Introduction == This section talks about the input and sensor location data of the uCAN and CAN Control. More settings however exist that are not described in this page....")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Introduction

This section talks about the input and sensor location data of the uCAN and CAN Control. More settings however exist that are not described in this page.

The Micro controller (Microchip 18F46K80) used in the CAN Control and uCAN has a built-in Eeprom. This Eeprom is used to store multiple setting of the module.

Eeprom locations

Below, you'll find the locations where the input and sensor data is stored:

For the CAN Control: