Difference between revisions of "CAN Eeprom pages"

From OpenMotics
Jump to navigation Jump to search
Line 16: Line 16:
 
!Description
 
!Description
 
|-
 
|-
!<div align="center">1</div>
+
!<div align="center">304</div>
!<div align="center">1</div>
+
!<div align="center">130</div>
|24V IN PS (Will supply power to the test board and CAN Control)
+
|Total number of CAN inputs
 +
|-
 +
!<div align="center">305</div>
 +
!<div align="center">131</div>
 +
|Total number of CAN sensors
 
|-
 
|-
 
|}
 
|}

Revision as of 18:23, 28 January 2021

Introduction

This section talks about the input and sensor location data of the uCAN and CAN Control. More settings however exist that are not described in this page.

The Micro controller (Microchip 18F46K80) used in the CAN Control and uCAN has a built-in Eeprom. This Eeprom is used to store multiple setting of the module.

Eeprom locations

Below, you'll find the locations where the input and sensor data is stored:

For the CAN Control:

Location DEC Location HEX Description
304
130
Total number of CAN inputs
305
131
Total number of CAN sensors