Difference between revisions of "CAN Eeprom pages"
Jump to navigation
Jump to search
(Created page with "== Introduction == This section talks about the input and sensor location data of the uCAN and CAN Control. More settings however exist that are not described in this page....") |
|||
| Line 10: | Line 10: | ||
For the CAN Control: | For the CAN Control: | ||
| + | |||
| + | {| class="wikitable" width="60%" | ||
| + | ! width="5%"|Location DEC | ||
| + | ! width="5%"|Location HEX | ||
| + | !Description | ||
| + | |- | ||
| + | !<div align="center">1</div> | ||
| + | !<div align="center">1</div> | ||
| + | |24V IN PS (Will supply power to the test board and CAN Control) | ||
| + | |- | ||
| + | |} | ||
Revision as of 18:15, 28 January 2021
Introduction
This section talks about the input and sensor location data of the uCAN and CAN Control. More settings however exist that are not described in this page.
The Micro controller (Microchip 18F46K80) used in the CAN Control and uCAN has a built-in Eeprom. This Eeprom is used to store multiple setting of the module.
Eeprom locations
Below, you'll find the locations where the input and sensor data is stored:
For the CAN Control:
| Location DEC | Location HEX | Description |
|---|---|---|
1
|
1
|
24V IN PS (Will supply power to the test board and CAN Control) |
