Input module front panel LED functionality

From OpenMotics
Jump to navigation Jump to search

The Leds on the Front panel of the Input Module have following Layout:

Input.jpg

8 leds:

  • Power Led: Green led
    • Solid Green: The module has power and the processor is running correctly
    • Off: No power or incorrect firmware
  • Status Led: Orange led
    • Solid orange: Module is in discovery mode (together will all other modules on the RS485 Bus)
    • Short On: When this module receives communication from the Master, the Status led will go on every few seconds (which is the normal behavior)
  • 8 Input Leds: Green leds
    • Solid green: When the connected switch is closed
    • Off: When the connected switch is open
    • Blinking: When the "input indicate" function is used (through maintenance mode) or when the indicate function in the portal is used (configuration of inputs)

Important Note: The 8 input leds of the input module can go into sleep mode (which happens automatically) so when the indication is not working and you need to have the leds working, go to maintenance mode and activate the leds again by using following instruction:

 basic action activate 64 1