Combell Installation Page

From OpenMotics
Jump to navigation Jump to search

Introduction

This page has been created to explain the general installation requirements for the Combell building.

Module installation and connectivity

  • Detailed explanation how the modules must be connected can be found here
Hardware Installation Guide

Schematic Overview

The below schematic overview shows the 4 floor connectivity plan:

Combell2.jpg

Bill of Material

  • Main Floor
Number Module Type
1
Power Supply 12VDC
1
Gateway Module
3
Input Module 8 ports
2
Output Module 8 ports
?
Output Module (Sun Screen mode) 8 ports 4 screens
0
Dim Control Module 8 ports
0
Temperature/Sensor Module 8 ports
0
Power Measurement Module 1 phase 8 ports
0
Power Measurment Module 3 phase 12 ports
0
Dali Module
  • First Floor
Number Module Type
1
Power Supply 12VDC
0
Gateway Module
3
Input Module 8 ports
2
Output Module 8 ports
?
Output Module (Sun Screen mode) 8 ports 4 screens
0
Dim Control Module 8 ports
0
Temperature/Sensor Module 8 ports
0
Power Measurement Module 1 phase 8 ports
0
Power Measurment Module 3 phase 12 ports
0
Dali Module
  • Second Floor
Number Module Type
1
Power Supply 12VDC
0
Gateway Module
3
Input Module 8 ports
2
Output Module 8 ports
?
Output Module (Sun Screen mode) 8 ports 4 screens
0
Dim Control Module 8 ports
0
Temperature/Sensor Module 8 ports
0
Power Measurement Module 1 phase 8 ports
0
Power Measurment Module 3 phase 12 ports
0
Dali Module
  • Third Floor
Number Module Type
1
Power Supply 12VDC
0
Gateway Module
3
Input Module 8 ports
2
Output Module 8 ports
?
Output Module (Sun Screen mode) 8 ports 4 screens
0
Dim Control Module 8 ports
0
Temperature/Sensor Module 8 ports
0
Power Measurement Module 1 phase 8 ports
0
Power Measurment Module 3 phase 12 ports
0
Dali Module

Note: In total, 44 sun screens will be installed spread over the 4 floors. The exact number of Output modules required on each floor still needs to be defined.

RS485 bus

  • For the RS485 bus (Blue connection in the above drawing), an UTP cable (Cat5 or better) is used to interconnect the different modules and floors.
  • 1 pair is used for the bus, another pair is used to interconnect the GND of the OpenMotics system.
  • All modules are interconnected in the Bus, the first and last module have the termination jumper set (see Hardware Installation Guide)

12VDC

  • Each floor has its own 12V power supply
  • This same Power Supply is also used to power the Sun screen Output modules (Green connection in the above drawing). Please use a double (12V and GND) cable of at least 1mm2 to interconnect the different sun screen output modules.