Leds Dim Control

From OpenMotics
Jump to: navigation, search

The Leds on the Front panel of the Dim Control Module have following Layout:

Dim Control.png

8 leds:

  • Power Led: Green led
    • Solid Green: The module has power and the processor is running correctly
    • Off: No power or incorrect firmware
  • Status Led: Orange led
    • Solid orange: Module is in discovery mode (together will all other modules on the RS485 Bus)
    • Short On: When this module receives communication from the Master, the Status led will go on (when for example an output is changing state)
  • 8 Output Leds: Green leds
    • Solid green: When the corresponding output is ON
    • Off: When the corresponding output is OFF
    • Blinking: When the "output indicate" function is used (through maintenance mode) or when the indicate function in the portal is used (configuration of outputs)

Important Note: The 8 output leds of the Dim Control module can go into sleep mode (which happens automatically) so when the indication is not working and you need to have the leds working, go to maintenance mode and activate the leds again by using following instruction:

 basic action activate 64 1